Moog-music Minimoog Voyager XL Manual do Utilizador descarregar pdf (Página 18)

Page 20

Voyager XL User’s Manual - The Components

Page 21

Voyager XL User’s Manual - The Components

Related Oscillator Controls:

Two other panel controls interact with the Voyager XL oscillators: Fine Tune and Glide. These controls are

located to the lower left of the Modulation Busses section

Fine Tune:

The FINE TUNE control is used to tune the oscillators ± 2 semitones for matching an

external reference pitch.

Glide Rate:

Glide enables a glissando effect between notes. The GLIDE RATE control adjusts the

rate of the glissando. The glide rate can vary from a very fast to a very slow glide. It can

be switched on or off using the GLIDE switch in the Voyager XL keyboard left-hand

controller section, or in the PANEL mode menu of the RME. You can also turn glide on

or off by sending a MIDI CC 65 message (0-63 = off, 64-127 = on).

Oscillator CV Inputs on the Patch Panel:

PITCH -

The PITCH jack allows you to connect an external CV or Expression Pedal to control the Voyager XL’ s

pitch. All three oscillators are effected by this connection. The effective input range is -5 to +5 V, where a

positive CV will add to the Oscillator FREQUENCY control knob settings, and a negative CV will subtract

from the settings. If an Expression Pedal is used, the pitch can only be made to increase, since the pedal

connection supplies only a positive voltage.

WAVE -

The WAVE jack allows you to connect an external CV or Expression Pedal to control the oscillator wave-

forms. All three oscillators are effected by this connection. The effective input range is 0 to +5 V; the result

is dependant upon the panel WAVE control knob setting (a positive CV will add to the setting of the WAVE

control knob).

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 99 100

Sem comentários

Moog-music Minimoog Voyager XL Manual do Utilizador Página 18